Clover Electronics CDR0460 DVR User Manual


 
MODEL: CDR1660 / CDR0860 / CDR0460 H.264 STAND-ALONE DVR USER MANUAL V 2.6
25
6.3.2. CONNECTION OF MONITOR
Connect the composite Video Output (VIDEO OUT) of the DVR to the Video IN of Monitor as
shown in the below diagram.
6.4. SENSOR CONNECTION
If you want, you can install sensors on your DVR system. There are four sensor signal input
terminals on the DVR. To install sensors on the DVR, follow the instruction below. The sensor
signal input terminals are on the rear panel of the DVR.
a) Connect the signal lines of the sensors as shown in below diagram.
b) Connect the power lines of the sensors.
< Model: CDR0860 >
NOTE:
Two signal input terminals are assigned to one channel.