Filter
Top Products
MODEL: CDR1660 / CDR0860 / CDR0460 H.264 STAND-ALONE DVR USER MANUAL V 2.6
35
7.6.2. MOTION RECORDING
Motion recording is yet another effective form of event recording that is triggered when a channel
detects motion in its field of view as the H.264 compression algorithm allows for accurate and
error-free motion detection.
Click the SETUP icon on the MENU bar or press the MENU button of the remote controller or the
front panel in the live mode and the MAIN MENU window will be displayed.
Click the RECORD in the MAIN MENU and the RECORD menu will be displayed.
Click the RECORDING SETUP in the RECORD menu and the RECORDING SETUP window will
be displayed.
Click the
button of the desired channel below the MOTION ( ) icon and the
MOTION menu will be displayed.
Select the MOTION RECORDING ON or OFF and set the other items to the desired values.
The channels which detect motion will display the
“MOTION” message and you can hear the beep
sound by 5 seconds interval for 30 seconds. The
REC button will light up and the channel status will
change the color to red in the channels in which
the motion was detected.
The recording will include the pre and post
recording time on the channels that are recording.
For a detailed explanation of each function and feature, refer to chapter 8.2.1.5 MOTION
RECORDING on page 65.
7.6.3. ALARM (SENSOR) RECORDING
Alarm recording is a form of event recording that triggers off of the circuit lines connected to the
terminal blocks in the rear of the DVR. Typical circuits comprise of normally closed circuits (NC)
and normally open circuits (NO). This unit can support only NO(Normal Open).
Click the SETUP icon on the MENU bar or press the MENU button of the remote controller or the
front panel in the live mode and the MAIN MENU window will be displayed.
Click the RECORD in the MAIN MENU and the RECORD menu will be displayed.
Click the RECORDING SETUP in the RECORD menu and the RECORDING SETUP window will
be displayed.
Click the
button of the desired channel below the ALARM ( ) icon and the
SENSOR menu will be displayed.