Filter
Top Products
3
CFA3000 ISE Analyzer
Instruction Manual
1.3 WARNING – Electrical Shock Hazard
Installation of cable connections and servicing of this product require access to shock hazard voltage levels.
Main power and relay contacts wired to separate power sources must be disconnected before servicing.
Nonmetallic cable strain relief does not provide grounding between conduit connections! Use grounding
type bushings and jumper wires.
Electrical installation must be in accordance with the National Electrical Code (ANSI/NFPA 70) and/or any
other applicable national or local codes.
Operate only with:
1. Main console rear cover fastened.
2. Left side power terminal cover closed.
3. Keypad assembly latched closed.
Safety and performance require that this instrument be connected and properly grounded through a three
wire power source.
Proper configuration and use is the responsibility of the user.
Mark
ID Description
EN 610101 Safety of electrical equipment
EN 55011 Limits of RF equipment
EN 500821:92
Generic immunity from electrostatic
discharge, RF & Fast
Transient/Burst Immunity
EtL
9700516
ETL LISTED CONFORMS TO UL
STD. 31011
EtL
ETL LISTED CERTIFIED
TOCAN/CSA C22.2 No. 1010.192