Filter
Top Products
26
CHAPTER 2 CONNECTING THE EMULATOR
■ Connecting (using flat cables and a probe header) to the user system
With a probe header compatible with the package of the regular-production MCU being used,
connect the probe header to the appropriate connector of the user system, as shown in Figure
2.3-2 "Connecting (using flat cables and a probe header) to the user system".
For more information on how to connect the connector of the probe header, see the operation
manual of the probe header used.
Figure 2.3-2 Connecting (using flat cables and a probe header) to the user system
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before connecting or disconnecting cables.
Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable.
Always grasp the power plug or connector itself. Pulling the cable may
expose conductors or sever wires in it, possibly resulting in device
problems, fire, or electric shock.
CAUTION
Prohibition
PROBE CN B2PROBE CN1 B1
To connect a flat cable, push its connector into the connector of the probe header until the eject locks on
both sides of the flat cable connector lock.
To disconnect a flat cable, pinch the eject locks on both sides of the flat cable connector until the flat cable
unlocks, and pull out the connector.
Flat cables
Probe header
User system
Eject locks