Filter
Top Products
28
CHAPTER 2 CONNECTING THE EMULATOR
2.4 Connecting a Probe
Connect a probe to the adapter board.
■ Connecting a probe
Note:
The adapter board has two pairs of probe connectors. Do not use both pairs at the same
time. Use only one of these pairs according to the configuration of the probe used.
■ Connecting a probe (using a probe cable)
Connect a probe cable to probe connectors A1 and A2 on the adapter board, as shown in
Figure 2.4-1 "Connecting a probe (using a probe cable)".
Figure 2.4-1 Connecting a probe (using a probe cable)
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before connecting or disconnecting cables.
Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable.
Always grasp the power plug or connector itself. Pulling the cable may
expose conductors or sever wires in it, possibly resulting in device
problems, fire, or electric shock.
CAUTION
Prohibition
PROBE CN A2PROBE CN A1
PROBE CN B2PROBE CN B1
Probe cable
Adapter board