Filter
Top Products
34
CHAPTER 3 OPERATING THE EMULATOR
3.1 Mounting an Evaluation MCU
Mount an evaluation MCU on the emulator.
■ Mounting an evaluation MCU
Pull the lever of an IC socket for an evaluation MCU on the emulator, and mount the evaluation
MCU while aligning the pin No. 1 index mark ( or ) of the evaluation MCU with that ( )
of the IC socket.
After mounting the evaluation MCU, push the lever of the IC socket back to its original position.
Figure 3.1-1 Mounting an evaluation MCU
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before mounting the evaluation MCU. Doing
so may result in device problems or electric shock.
CAUTION
Prohibition
(Top view) (Side view)
Pin No. 1 index mark
IC socket for the evaluation MCU IC socket for the evaluation MCU
Evaluation MCU
Evaluation MCU