Filter
Top Products
29
2.4 Connecting a Probe
■ Connecting a probe (using flat cables)
Connect flat cables to probe connectors B1 and B2 on the adapter board, as shown in Figure
2.4-2 "Connecting a probe (using flat cables)".
Figure 2.4-2 Connecting a probe (using flat cables)
Make sure that power to the product is turned off and the power plug is
disconnected from outlets before connecting or disconnecting cables.
Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable.
Always grasp the power plug or connector itself. Pulling the cable may
expose conductors or sever wires in it, possibly resulting in device
problems, fire, or electric shock.
CAUTION
Prohibition
PROBE CN B2PROBE CN B1
PROBE CN A2PROBE CN A1
Adapter board
Flat cables
Eject locks
To connect a flat cable, push its connector into probe connector B1 or B2 until the eject locks
on both sides of the flat cable connector lock.
To disconnect a flat cable, pinch the eject locks on both sides of the flat cable connector until
the flat cable unlocks, and pull out the connector.