Filter
Top Products
96 HP MediaSmart HDTV User Guide
Remote control questions
Symptom Remedy
The remote control does not work. Check the following, and try the proposed solution:
■ Make sure that the batteries are inserted with the polarity properly
aligned.
■ Make sure that the remote control batteries are fresh. If they are worn
out, replace them with new batteries.
■ Make sure that the remote control is within correct operating range.
■ Make sure that the remote sensor window on the front of the TV is not
under too much light, direct sunlight, or strong artificial light.
■ Make sure that no obstacles are between the remote control and the
sensor window on the front of the TV.
■ Make sure that the remote control is aimed at the TV and is not farther
than 16.4 feet (5 meters) away.
I cannot add a channel to the Fav
button favorite channel list.
To be able to add a channel to the Fav button favorites list, the channel
must be in the channel list. The Setup Wizard, or the Auto Scan in the
OSD Channel menu, creates the channel list when it searches for
channels. Run the Setup Wizard or the Auto Scan; see “Starting the
Setup Wizard” on page 64 or “Searching for channels” on page 56.
The remote control does not control
other home entertainment equipment.
■ Try all listed codes for the equipment brands you are trying to set up,
or try programming the remote control using the auto setup mode.
Refer to “Programming the Remote Control for a Home Entertainment
Device” on page 43.
■ Make sure the equipment can be operated with an infrared remote
control.
The remote control does not blink the
selected device button (TV, AUD,
STB, AUX) when I push a button.
Replace the batteries in the remote control.