Filter
Top Products
26 HP MediaSmart HDTV User Guide
Setting up a wired connection
1 Point the remote control at the remote control
sensor on the display and, if necessary, press the
Device button to light the TV indicator.
2 Press the Media button.
When you press the Media button on the remote
control for the first time, a wizard guides you
through the network setup at the TV and at the PC
(by using the Installation CD).
3 Follow the onscreen instructions. For a wired
connection, the wizard checks for the network, the
IP address, and then for access to the Internet
across the network.
If the TV shows an error message:
■ Check that the wired LAN (Ethernet) cable is
properly connected at the TV and the router.
■ Check that the computer, router, and other
network equipment are all turned on.
4 The TV shows a message when it is time to set up
the PC using the Installation CD, which is included
in the box. Insert the Installation CD into a CD
drive on your PC.
5 Follow the onscreen instructions to:
■ Install and set up Windows Media Player 11,
and then authorize your MediaSmart TV and
add media folders to the Windows Media
Player Library.
■ Set up Online Services.
6 Click Finish when the installation is complete at
your PC.
7 Go to your TV and press OK on the remote
control.
Wait while the TV looks for authorized servers on
the network.
8 Press the Media button to display the main digital
media menu. To use the menu, refer to “Using
Digital Media” on page 67.
Setting up a wireless connection
1 Ensure that the wireless network is working.
2 Point the remote control at the remote control
sensor on the display and, if necessary, press the
Device button to light the TV indicator.
TV AUD STB AU
X
Device
On/Off
Media
n
The Installation CD installs the MediaSmart
software on your PC. This software
supports playback of some files that
Windows Media Player 11 may not; see
“Supported Media File Types” on page 89.
n
The TV Standby Mode is Power Saver by
default. To start quickly from the standby
state, especially when using digital media,
change the Standby Mode to Fast Start in
the OSD Setup menu; see “Setting the
Standby Mode” on page 65.
TV AUD STB AU
X
Device
On/Off