Filter
Top Products
Chapter 2 Introducing TopTools Remote Control
13
• The server must also have been initially set up with a Network Operating
System and the HP NetServer SNMP agents installed. HP TopTools
Remote Control uses these agents to perform certain functions. If you are
not sure, refer to the HP NetServer SNMP agent installation instructions
available from the Information Assistant program on the HP NetServer
Documentation CD that came with your NetServer.
• An external modem (required only for paging and dial-up remote access).
A list of recommended modems is included in Appendix B. An updated
(most current) list may be found on the Tested Products List for your
particular HP NetServer. To view this list, refer to Appendix B.
• A dedicated 10Base-T compatible LAN connection (required for email
notification and LAN access) and a unique IP address for the HP
TopTools Remote Control card (either fixed or DHCP).
• For HP NetServers running Windows NT 3.51 or 4.0, full graphics
console redirection to the remote client is available using Symantec’s
pcANYWHERE32 (see Chapter 6, Setting Up NT Graphics Console
Redirection Using pcANYWHERE32).
Minimum Remote Client Requirements
To access HP TopTools Remote Control, you need the following:
• A personal computer with an Intel Pentium processor
• A VGA color display (800 X 600, greater than 256 colors minimum
resolution)
• Microsoft Windows 95 (with Service Pack 1), Windows 98, or Windows
NT 4.0 (with service pack 3)
• TCP/IP stack (included with Microsoft Windows software)
LAN Connection Requirements
To access HP TopTools Remote Control via LAN, you need the following:
• LAN connection with 10Mbit support
• Supported Web Browser (see below)
• pcANYWHERE32 Version 8.0 for Windows NT server console
redirection (included on HP NetServer Navigator CD)