Filter
Top Products
41
6 Setting Up NT Graphics Console
Redirection Using pcANYWHERE32
For NetServer systems running Microsoft Windows NT 3.51 or 4.0, you can
redirect the server’s NT graphics console to a remote PC client to remotely
perform operations as if you were sitting at the server. To do this, you must
install pcANYWHERE32 software. pcANYWHERE32 components must be
installed and configured at both the server and the remote client to use NT
remote control. The figure below show how it works:
NetServer
At the Server:
after
installing pcANYWHERE32
and configuring it for LAN
and/or modem
communications, the
server may be taken over
by the remote client via a
LAN and/or modem
connection.
At the Remote Client Using
aModem:
the user dials into
HP TopTools Remote
Control, selects "NT Remote
Control," hangs up and dials
back to the server using
pcANYWHERE32 and takes
full graphics control of the
HP NetServer.
Remote
Console
Modem
Modem
LAN
At the Remote ClientUsing
the LAN:
the user launches
pcANYWHERE32 and takes
full graphics control of the
HP NetServer.
LAN
Figure 6-1. NT Console Redirection to a Remote Client