Hitachi VHS VT-S772A VCR User Manual


 
Getting Started - 12 -
If you have been watching the TV in your home before getting the VCR, you will
already have a round wire attached to your TV. Otherwise, look for a cable connection
coming in through the wall from outside. (If you find this connection, remember to call
your local cable company to start the service.)
1. If still hooked up to your TV, unscrew the round wire from the 75 ohm connector on
your television. Otherwise, take the wire that comes in from the wall.
2. Screw this round wire into the IN FROM ANT upper jack on the back of your VCR.
3. Using the 75 ohm cable supplied with your VCR, slide on either end to the OUT TO
TV lower jack on the back of the VCR.
4. Connect the other end of the same cable onto the 75 ohm antenna input on your TV
(where you first disconnected the TV in step 1).
Capabilities: With this hookup, you should now be able to perform all the basic
functions provided by this equipment.
External or Internal 300 Ohm Antenna
If you have either an external or internal (rabbit ears) antenna rather than cable, you
may have 300 ohm connectors like these