Hitachi VHS VT-S772A VCR User Manual


 
Getting Started (Controls) - 15 -
When the VCR is on, its video signal can come into your TV on
either channel 3 or channel 4. You need to select the appropriate channel.
 Turn the power on to both the TV and the VCR, and look for a switch on the back of
the VCR. Set the switch to 3 or 4, whichever is not a commercial channel in your area.
Your basic hookup is now complete. When you're ready to try hooking up a second
VCR, a video camera, or a stereo for a complete home entertainment system, see
Advanced Operations.
Now turn the TV and VCR back around facing you and begin your quick tour of the
controls (page 16).
Getting Started (Controls)
 Quick Tour of the Controls
Study these pictures carefully to learn about the buttons and controls that you'll need
for everyday operation. Various controls are explained throughout this manual as they
are needed, but now is a good time to get familiar with their locations.
Most of the time, you'll be directing the VCR from the remote control, but there are
some controls on the VCR that will come in handy too.
When you're familiar with these basic controls, proceed to Initial Setup (page 23).
We'll show you how to program your local channels.
How the Remote Control Works
Pressing a button on the remote control transmits an invisible beam of light (infrared)
to a receiver at the left front of the VCR.
When using the remote, aim the front end toward the VCR and make sure nothing -
such as a coffee table or your dog - is blocking the path of the infrared beam.