Filter
Top Products
Getting Started (Initial Setup) - 20 -
Now, you will do most of your programming and setup by pressing numbers on the
remote control which correspond to options presented in this and other on-screen
menus. Instructions are easy to follow, and blinking spaces on the screen will show
you where your input is needed.
When you want to leave the Easy Guide System, simply press GUIDE several
times. This will back you out to the normal TV viewing screen.
If you don't press any button for a while, the VCR will switch you back to an earlier
screen or to regular TV viewing.
Getting Started (Initial Setup)
Setup for First-Time Operation
Before you use your VCR to watch or record from your TV, you need to "tell" the VCR
whether your TV uses cable or antenna input and let it program itself to receive your
TV's channels. It's also a good idea to set the clock so you can do timed recording
later. With your TV and VCR hooked up, turn them both on and follow these steps
using the remote control.
Initial Setup Options
Press GUIDE, then press 1 to bring up the Initial Setup screen.