Filter
Top Products
Filename [DR-M1EK_06Name.fm]
Masterpage:Left+
Page 24 August 26, 2003 2:04 pm
INITIAL SETTINGS (cont.)
24
Results of Auto Set Up/Preset Download appearing on the front display panel
If both Auto Channel Set and Auto Clock Set have been performed successfully, the
correct current time is displayed.
Turn on the TV and select its AV mode, then make sure that all necessary stations have been stored
in the unit’s memory by using the PR +/– button(s).
● If station names (ID –
੬
pg. 102) have also been stored in the unit’s memory, the station name
will be displayed at the top right corner of the TV screen for about 5 seconds when the unit is
tuned to a different station.
● If you want to set the tuner manually such as to add or skip channels, to change channel
positions, or to set or change station names, see pages 99 – 102.
If Auto Channel Set has succeeded but Auto Clock Set has not, “PR 1” (channel
position) is displayed.
OR
If both Auto Channel Set and Auto Clock Set have failed, “– –:– –” is displayed.
A
Turn on the TV and select its AV mode, then make sure that all necessary stations have been
stored in the unit’s memory by using the PR +/– button(s).
● If station names (ID –
੬
pg. 102) have also been stored in the unit’s memory, the station name
will be displayed at the top right corner of the TV screen for about 5 seconds when the unit is
tuned to a different station.
● If you want to set the tuner manually such as to add or skip channels, to change channel
positions, or to set or change station names, see pages 99 – 103.
B
Perform “Clock Set” on page 104.
NOTE:
After making sure the cables are connected properly, turn off the unit’s power once, then turn the
unit’s power back on again.
Perform “Auto Set Up” on page 21 or “Preset Download” on page 23 again.
IMP
O
RTANT:
● To check if the Guide Program numbers have been set correctly, perform the VIDEO Plus+ Timer Programming. (
੬
pg. 56)
● In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work
properly. If the Guide Program numbers are not set properly when you timer-record a TV programme using the VIDEO Plus+
system, the unit will record a TV programme of a different station. When programming the timer using the VIDEO Plus+ system,
be sure to check the desired channel is selected correctly. (
੬
pg. 56, “VIDEO Plus+
®
Timer Programming”)
● Your unit memorizes all detected stations even if reception of some of them is poor. You can delete those stations with an
unacceptable picture. (
੬
pg. 100, “Delete A Channel”)
INFORMATION
Just Clock
Your unit is equipped with the Just Clock function which provides accurate time keeping through automatic adjustments at regular
intervals, by reading data from a PDC signal. If you want to take advantage of this function, simply set it to “ON”. (
੬
pg. 104, “Just
Clock”)
If you have any difficulty with the above procedures call the JVC Customer Service Hot Line
on 0870 330 5000
DR-M1EK_06Name.fm Page 24 Tuesday, August 26, 2003 2:07 PM