Filter
Top Products
Filename [DR-M1EK_08Recording.fm]
Masterpage:Left+
Page 64 September 4, 2003 11:33 am
TIMER RECORDING (cont.)
64
When programmes overlap each other
If “PROGRAM OVERLAPPED” appears, you have another
programme overlapping the programme you have just made.
Confirm with the arrow on “OK”, then press
PROG/CHECK
.
Programme Check screen appears and conflicting programmes
will be highlighted in pink.
Example: Programme 3 (you have just made) and
Programme 4 overlap each other.
A
Confirm the overlapping programmes.
Overlapping programmes appear on the TV screen.
NOTE:
If you do not mind this overlap, press
PROG/CHECK
to finish
the timer programme setting. The programme with the lower
programme number will be recorded and the other one will not
be recorded correctly. If no changes are made for approximately
1 minute, the unit will return to the normal screen.
B
Select the desired programme to be cancelled
or changed.
Press
rt
.
To cancel the programme
Press
&
.
● “THE TIMER PROGRAMMING SETTING WAS CANCELLED”
appears on the TV screen for about 5 seconds, then the normal
screen resumes.
To change the programme setting
Press
ENTER
.
C
Change the programme setting.
● Refer to steps
D
–
J
in “Manual Timer Programming”
(
੬
pg. 58).
D
Check if the conflict has been settled.
Press
PROG/CHECK
.
● Programme check screen appears.
E
Engage the unit’s timer mode.
● Refer to step
F
in “Check, cancel and change programmes”
(
੬
pg. 63).
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure
above until the conflict is solved.
DR-M1EK_08Recording.fm Page 64 Thursday, September 4, 2003 11:34 AM