Filter
Top Products
Masterpage:Right-No-Heading
Filename [DR-M1EK_11Subsidiary.fm]
Page 95 August 26, 2003 2:49 pm
95
DISPLAY SET
(The boldface settings in the table below indicate the settings at your purchase.)
8 SUPERIMPOSE
OFF
AUTO
ON
You can select the modes of indications superimposed on the TV screen.
OFF
:
To turn off superimposed indications.
AUTO
:
To superimpose operational indications for approximately five
seconds just after the corresponding operation.
ON
:
To superimpose operational indications all the time.
NOTES:
●
When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE”
to “OFF” before starting. (
੬
pg. 83, “Edit To Or From Another Recorder”)
●
When you select “AUTO”, during playback, the operation mode indicators may be
disturbed depending on the type of disc being used.
8 GREY BACK
OFF
ON
When this function is set to “ON”, the TV screen becomes all grey when
receiving a channel not in use.
NOTE:
When you want to receive an unstable channel with poor signals, set this function to
“OFF”.
8 DIMMER
BRIGHT
DARK
You can change the brightness of the front display panel.
BRIGHT
:
Normally select this.
DARK
:
To dim the front display panel. (Blue lamp on the front display panel
is turned off.)
8 POWER SAVE
OFF
ON
When this function is set to “ON”, you can reduce the power consumption
while the unit is turned off.
NOTES:
●
During Power Save mode —
— the front display panel will be turned off.
— the Just Clock function (
੬
pg. 104) does not work.
●
Power Save does not work when —
— the unit is in the Timer mode.
— the unit’s power is turned off after timer-recording or Instant Timer Recording.
— the Automatic Satellite Programme Recording mode is engaged. (
੬
pg. 65)
— “L-2 SELECT” is set to “DECODER”, “SAT VIDEO” or “SAT S-VIDEO”. (
੬
pg. 85)
●
It takes some time for the unit to complete initialisation after you turn on unit power,
with “WAKE UP” blinking on the front display panel.
DR-M1EK_11Subsidiary.fm Page 95 Tuesday, August 26, 2003 2:49 PM