Filter
Top Products
15
English
3139 246 XXXXX
Option 4 : Using Antenna
jacks only
Use this connection only if your TV set
has a single Antenna In jack and does
not have any audio/video jacks. For this
type of connection, you need to set the
channel of the TV set to follow that of
the DVD recorder.
Have the following cable ready:
1) Antenna cable
1 Turn off your TV and remove the
antenna cable from your TV (or Satellite
Receiver/Cable Box.) Insert it to the
ANTENNA input jack at the back of
the DVD recorder.
2 Use the supplied antenna cable to
connect the DVD recorder’s TV output
jack to the antenna input jack at the back
of your TV set.
3 Connect the power cable from the DVD
recorder’s ~ MAINS to the power
supply.
TV
1
2
3
4
Press STANDBY-ON 2 on the DVD
recorder to turn it on.
➜ The message 'IS THE TV ON?'
appears on the display panel.
5 Turn on the TV power. Select the correct
Video In channel at the TV (see page 10.)
➜ To switch between channel 3 and 4,
hold down button {3} or {4} on the
remote control to select the respective
channel.
➜ The first installation menu
{ Language and Country } will appear
on the TV.
6 Proceed to page 24 to continue the first
installation.
Helpful Hints:
– If the {LANGUAGE AND COUNTRY}
menu does not appear, check the cable
connections.
– To toggle between channel 3 and channel
4, you can press § button at the DVD
recorder front panel while plug in the main
cord of the DVD recorder to the power
supply.
Connecting to TV (cont’d)
Antenna or
Satellite/Cable TV signal
MRV660_17_Eng40 9/3/05, 10:24 AM15