Mitsubishi Electronics DX-TL950E DVR User Manual


 
85
ENGLISH
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Troubleshooting
If problems with the unit persist even after youve followed the suggestions below, please disconnect the power cord
and contact the retailer from whom you purchased the unit.
The unit will not turn on.
Power is on, but the unit
will not operate.
Images are not appearing
on the monitor.
The quality of the monitor
picture is poor.
The unit will not start
recording.
The unit will not stop
recording.
The unit will not perform
Repeat Recording.
The unit will not perform
Timer Recording.
The unit will not perform
Alarm Recording.
Is the power cord properly plugged in?
Is the LOCK indicator light on?
Is the TIMER button light on?
Is the MAIN switch on the rear set to OFF ?
Is the LOCK indicator light on?
Is the POWER button blinking?
(The unit cannot be operated when the POWER button is flashing.)
It is possible that the safety features are in operation.
Restart the unit by pressing the RESET button located on the back
of the unit using a ballpoint pen or similar object.
Are the monitor and camera(s) connected correctly?
Is the unit receiving an input signal from the selected camera?
Check this by setting the unit to SPLIT9.
Is OUTPUT B ON/OFF set to ON?
Video from OUTPUT B will not be displayed when OFF.
Is the connecting cord connected correctly?
Is the cameras focus adjusted correctly?
Is the HDD REPEAT REC MAIN set to OFF or STANDBY and
HDD REPEAT REC SUB set to OFF?
The unit begins recording only after the specified recording time.
Was the unit stopped during the specified recording time?
Is the LOCK indicator light on?
During normal recording, alarm recording and emergency
recording, press the REC/STOP button for more than 1 second.
Is timer recording in progress?
To stop timer recording, press the TIMER button again for more
than 1 second.
Is the HDD REPEAT REC MAIN and HDD REPEAT REC SUB
set to ON?
Are the date and current time set accurately?
Are the Recording Start-/End-times and the recording interval
set correctly?
Is the HDD REPEAT REC MAIN set to OFF or STANDBY and
HDD REPEAT REC SUB set to OFF?
Is the A-PPS in the <RECORD SETTING> set as - - - - - -?
Is the SUB HDD recordable capacity full?
Is the unit in timer recording stand-by mode?
(Is the TIMER button light on?)
Are the peripheral switches, etc., connected correctly?
INSTALLATIONRECORDING
PagePlease consult the followingDescription of problem
-
11,56-58
10
13
11,56-58
10
13,74
15
36
37
-
-
47
22,23
11,56-58
10,23
10
47
20,21
44-46
47
41,42
47
10
15
Troubleshooting