Mitsubishi Electronics DX-TL950E DVR User Manual


 
87
ENGLISH
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Warnings and CALL OUT output
Warnings and their appropriate countermeasures
#1 Options in the CALL OUT options column:
Selectable : CALL OUT output can be selected/de-selected on the menu.
Fixed : a CALL OUT signal is emitted without prior selection of this function using the menu.
None : no CALL OUT signal is emitted, but a warning indicator will appear on screen.
CALL OUT signal output can be stopped by pressing the WARNING RESET button.
Warning Display
CALL OUT
output
#1
page
Canceling
the warning
Code
Status
Countermeasure
REC/FULL
REC/SUB FULL
COPY/FULL
REST/FULL
REC/REM
COPY/SIZE/
DATA ERROR
REST/SIZE/
DATA ERROR
COPY/
MEDIA ERROR
REST/
MEDIA ERROR
COPY/NO MEDIA
REST/NO MEDIA
NO SIGNAL
(The warning will
indicate the number
of the non-functioning
camera. )
WNG1100
WNG1101
WNG3100
WNG4100
WNG1200
(MAIN)
WNG1201
(SUB)
WNG3701
WNG4701
WNG3702
WNG4702
WNG3703
WNG4703
WNG54 #3
47
72,73
-
-
72,73
72,73
-
11,72
11,72
15
36
22,23,
41-43
Selectable
None
Selectable
None
None
None
Fixed
MAIN HDD recordable
capacity is full.
SUB HDD recordable
capacity is full.
Media recordable
capacity is full.
The remaining HDD capa
-city has reached the value
set in HDD REMAIN.
The data that is being
copied exceeds the
capacity ofCompact Flash
Card, or there is no
original data.
It restored from the
Compact Flash of a
different format.
Error has occurred in the
media as Compact Flash.
No inserted media as
Compact Flash.
Video signal was lost for
more than 5 seconds
during recording.
Press the
WARNING
RESET button.
Press the
WARNING
RESET button.
Press the
WARNING
RESET button.
Press the
WARNING
RESET button.
Press the
WARNING
RESET button.
Press the
WARNING
RESET button.
Stop recording.
Output video
signals.
Press the
WARNING
RESET button.
When the warning is
cancelled, the unit will start
over-writing the oldest data
remaining in the hard disk
drive.
Copy data as necessary.
Replace with new media.
Replace media if necess
-ary.
Copy data as necessary.
Set the copy/restore
range again.
Replace with new media.
Check media in recording
device. (Insert the media
if there is none.)
Insert the media.
Check whether the unit
and camera are properly
connected, and that electri
-city is on.
Check whether the visual
signal is being properly
outputted.
Check to see if there is a
camera set for operation
with no video signal input.
Warnings and CALL OUT output