Filter
Top Products
5
4BGFUZ5BC
4UBOE
4UBOE4DSFXT
%JTQMBZ
Stand Removal Instructions
1. Before performing work, make sure to
disconnect the AC power cord from the display.
2.
Before performing work, spread the protective
sheet that was wrapped around the display
on a flat, even surface (such as a table). The
protective sheet will prevent the display from
being damaged.
3. Gently place the display face down on the
protective sheet with the display stand hanging
over the edge of the table. See the illustration
to the right.
CAUTION: The stand is heavy and can fall, so
two people are needed to safely remove it.
4. Remove the small cover on the back of the
display. See the illustration to the right. Press
on the small tab to release the cover. Keep
the cover and reinstall it after connecting the
display to the media center.
5. With the stand hanging over the edge of the
table, have one person hold the stand firmly
with both hands while the other person uses a
screwdriver to remove the six (6) stand screws.
See the illustration to the right.
6. While the first person continues to hold the
stand firmly, have the other person unscrew
the Safety Tab screw. See the illustration to the
right.
7. The person holding the stand can now put the
stand carefully in a safe place for future use.
8. The display is now ready for mounting. Refer to
the instructions provided with the Wall Mount
Kit (purchased separately).
5BCMF
1SPUFDUJWF
TIFFU
%JTQMBZ
4UBOE
CAUTION
• A minimum of TWO PEOPLE are needed to safely remove the stand.
• One person needs to hold the stand while the other person removes the stand screws.
This is necessary to prevent the stand from falling to the floor.
• Failure to follow these recommendations may result in personal injury as well as damage to the
product.
Wall Mount Kit
To order a Wall Mount Kit (Part #
PSM-2048)
:
Please call the
Mitsubishi
Parts Department at: (800) 553-7278
or call Chief Manufacuring,
Inc. at: (800) 582-6480.
BEFORE MOUNTING THE DISPLAY TO A WALL:
Be sure to connect a VGA cable to the
display PC (video) Input, and if applicable,
a stereo mini cable to the PC Audio Input.
Otherwise, you will not be able to access
the PC Inputs after wall-mounting.
The media center does not have PC inputs.
See Chapter 6 for more information.
IMPORTANT
Step 4: Remove the
small cover to access
stand screws and the
AC power input.