Filter
Top Products
Chapter 6: Connecting and Using a PC
82
Figure 1. Connecting a PC to the Display
Connecting a PC to the Display
Figure 1. A 15 pin PC monitor cable and an audio video cable is required. These are not included with the TV.
To connect a PC to the display (audio and video), do the following:
1. Connect a VGA video cable (purchased separately) from the PC to the VGA port on the rear panel of the display.
Refer to the Supported PC Timings table on page 85.
2. Connect a Stereo Mini audio cable (purchased seperately) from the display rear panel to the PC (the Headphones
terminal can be used for this purpose).
Note: The display’s PC video input is only compatible with VGA, SVGA, XGA, or SXGA resolutions.
If your PC has digital audio output, connect that terminal to a digital input of your digital A/V receiver, if available.
The HDTV (display and media center) only supports analog PC audio.
3. Add the device (PC) in the NetCommand® menu.
4. Select the PC through the Device Selection menu.
1$3FBS1BOFM
XJUI7JEFP0VUQVU
BOE"VEJP0VUQVU
%JTQMBZ3FBS1BOFM
6)$%//54
!5$)//54
IMPORTANT:
BEFORE MOUNTING THE DISPLAY TO A WALL
Be sure to connect a VGA cable to the display PC (video) Input, and, if
applicable, a stereo mini cable to the PC Audio Input. Otherwise, you
will not be able to access PC Inputs after wall-mounting. The media
center does not have PC inputs.