Multi-Tech Systems RF310E Universal Remote User Manual


 
RASFinder RF300E/RF310E User Guide
RF300E/RF310E138
Command: O
Function: Return Online
Unit: n/a
Values: n/a
Default: n/a
Description: The O command returns the TA to online mode from the online command mode.
When the TA makes a data connection, it enters online data mode. The TA typically
remains in this mode until it receives an escape sequence or until the call is ended.
When it detects an escape sequence, the TA enters online command mode, in which
it can accept AT commands while retaining the online connection. To return the TA to
online mode from the online command mode, enter the command ATO<CR>.
D.1.7 Analog (Modem) Call Commands
Use these commands to make or configure analog (POTS) calls.
Command: *An
Function: Answer Analog Call
Unit: Decimal ASCII code
Values: n=0 (Analog Port 0)
n=1 (Analog Port 1)
Default: *An (n=TA port number which command is given)
Description: The *An command forces the TA to answer an incoming analog call on analog port n.
If n is not specified, then n is assumed to be 0.
Command: *Bn
Function: Send Analog Call Digit
Unit: ASCII
Values: n=0-9,A,B,C,D,*,#
Default: n/a
Description: The *Bn command forces the TA to send a dial digit to the analog port associated
with the command port this command is given (Analog Port 0).
Command: *Dn
Function: Dial Analog Number
Unit: ASCII
Values: n=dial string composed of 0-9,A,B,C,D,*,#
Default: No dial string
Description: The *Dn command causes the TA to dial an analog telephone number (e.g.,
AT*D785-3500<CR>). The dial string can contain up to 80 characters.
Command: *Hn
Function: Hang Up Analog Call
Unit: Decimal ASCII code
Values: n=0 (Analog Port 0),
n=1 (Analog Port 1)
Default: *Hn (n=TA port number which command is given)
Description: The *Hn command spoofs the TA into believing the analog port went on-hook (hung
up).
Command: *!Hn
Function: Analog Call Hold-Off Time
Unit: 1 second
Values: n=0 (disable),
n=1-255 (1-255 seconds)
Default: *!H0 (disabled)
Description: When an analog call disconnects a timer will be installed that will hold off incoming