Filter
Top Products
Chapter 5 - Client Setup
RF300E/RF310E 85
7. In the Network Protocols list select TCP/IP, then click Properties. The Microsoft TCP/IP
Properties dialog box is displayed.
8. Click the IP Address tab.
The IP addressing method depends on how your RASFinder’s DHCP Server option was
configured. If DHCP Server is active, your IP address is issued automatically. If your network
administrator did NOT activate DHCP Services on the RASFinder, you will have to assign your IP
address manually.
Verify the RASFinder/DHCP status with your network administrator, then proceed to step 9 for
DHCP assigned addressing, or to step 10 for manual addressing.
9. If DHCP Services are active on the RASFinder (the default), verify that the Obtain an IP address
from a DHCP server option is enabled (checked). At this point, you are done. Go to step 20 and
attempt to open an Internet session.
10. If DHCP Services are NOT active on the RASFinder, you may have to manually enter your IP
address. Select manual addressing by clicking the Specify An IP Address option. The IP
Address and Subnet Mask fields become active.