Panasonic AJ-HD150 VCR User Manual


 
– 61 –
USER menu
<EDIT>
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
300 IN/OUT 0000 MANU
DEL 0001 AUTO
301 NEGA 0000 OFF
FLASH 0001 ON
302 CONFI EDIT 0000 OFF
0001 ON
305 AUTO 0000 DIS
ENTRY 0001 ENA
306 CF ADJ 0000 PLAYER
SEL 0001 RECORD
307 AFTER 0000 STOP
CUE-UP 0001 STILL
308 VAR FWD 0000 +4.1
MAX 0001 +1.85
0002 +1
309 VAR REV 0000 –4.1
MAX 0001 –1.85
0002 –1
310 JOG FWD 0000 +4.1
MAX 0001 +1.85
0002 +1
The underline on the setting item denotes the initial setting.
This selects the operation to be performed when an edit point
has been set incorrectly (when the OUT point is before the IN
point).
0: Editing is not executed unless the illegal edit point is
cleared or set again properly.
1: The edit points already input are automatically cleared.
This selects whether to show a negative display when the IN
point is greater than the OUT point.
0: No negative display.
1: Negative display.
This selects whether to conduct simultaneous playback while
editing is in progress.
0: No simultaneous playback
1: Simultaneous playback
<Note>
Simultaneous playback is valid when the TAPE/EE switch is
set to TAPE.
This selects whether the IN point is to be entered using the
PREROLL button when it has not been entered.
0: IN point is not entered.
1: IN point is entered.
This selects the CF adjustment deck with deck-to-deck
editing.
0: The player’s edit IN/OUT points are adjusted. (reference as
the RECORDER side)
1: The recorder’s edit IN/OUT points are adjusted. (reference
as the PLAYER side)
This selects the mode after cue-up operation is complete.
0: STOP mode
1: SHTL STILL mode
This sets the maximum VAR FWD speed.
0: +4.1× speed
1: +1.85× speed
2: +1× speed
<Note>
At any speed setting other than 0 (+4.1×), the phase cannot
be synchronized from the editing controller.
This sets the maximum VAR REV speed.
0: –4.1× speed
1: –1.85× speed
2: –1× speed
This sets the maximum JOG FWD speed.
0: +4.1× speed
1: +1.85× speed
2: +1× speed
<Notes>
The maximum speed is set to +1× when the dial on the front
panel is operated.
At any speed setting other than 0 (+4.1×), the phase cannot
be synchronized from an editing controller which synchro-
nizes the phase using the JOG command.
Setup menus