Filter
Top Products
– 66 –
Setup menus
USER menu
<TIME CODE> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
509 PHASE 0000 OFF
CORR 0001 ON
510 TCG CF 0000 OFF
FLAG 0001 ON
511 DF MODE 0000 DF
0001 NDF
512 TC OUT 0000 V OUT
REF 0001 TC IN
The underline on the setting item denotes the initial setting.
This selects whether to control the phase correction of the
LTC generated by the TCG.
0: Phase correction control is not performed.
1: Phase correction control is performed.
This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
1: CF flag is ON.
This selects the DF/NDF mode for CTL and TCG.
0: Drop frame mode.
1: Non-drop frame mode.
<Note>
•
The drop frame mode takes effect only when LOCAL is
established or when ENA has been selected as the setup
menu item No.111 (LOCAL ENA) setting.
This is used to switch the phase of the time code, which is
output from the TIME CODE OUT connector, for the external
LTC input when the TC INT/EXT switch is at the EXT position.
(In EE mode only)
0: Time code is synchronized with output video signal.
1: Time code is synchronized with external time code input.
SBC (sub code data) area:
This area is separate from the video and audio data area on the helical track. The time codes, recording dates and times, and
other tape control information complying with SMPTE/EBU standards are stored here. As with the conventional LTC (linear time
code), the time code can be read even during rewinding or fast forwarding. It can also be read out when the tape has stopped.
VAUX (video auxiliary data) area:
This area is to be found in the video data area on the helical track. The additional information relating to the video data is stored
here.
Setup menus