9
RQT7394
Getting started
Enjoy multi-channel surround sound on DVD by connecting an amplifier and speakers. There are two types of connection, digital and analog.
∫ Analog connection ∫ Digital connection
Use one of the following connections to suit the antenna lead.
≥If your television has both lead and coaxial VHF terminals, use
the lead connection to minimize signal loss.
∫ A single twin lead
∫ A twin lead and a coaxial cable
∫ Two twin leads
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television’s operating instructions.
∫ A twin lead and coaxial plug terminal
∫ A twin lead terminal
∫ Two twin lead terminals
∫ Multiple antenna terminals
≥Connect to one of the ANT terminals, then change the television’s
settings as necessary.
Connecting an amplifier or system component
If the antenna connector doesn’t match
YPB PR
R - AUDIO - L
VIDEO
S-VIDEO
OPTICAL
G-LINK
COMPONENT
VIDEO OUT
(480p/480i)
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
IN1 (L1) IN3 (L3)
R - AUDIO - L
VIDEO
S-VIDEO
OUT1 OUT2
VHF/UHF
RF IN
RF OUT
SUB WOOFER
CENTER
RL
FRONT
AUDIO OUT
jLAN (10/100)
5.1ch
R - SURROUND - L
OPTICAL IN
FRONT
R L
SURROUND
R L
CENTER
SUB-
WOOFER
Optical digital audio
cable
Do not bend sharply
when connecting.
Insert fully, with this
side facing up.
Audio cable
This unit
Red White
Red White
To enjoy multi-channel surround sound on DVD-
Video connect an amplifier with a built-in decoder
displaying these logo marks. Use an optical digital
audio cable and change the settings in “Digital Audio
Output” (➡ page 63).
≥You cannot use DTS Digital Surround decoders not
suited to DVD.
≥Even if using this connection, output will only be from 2 channels
when playing DVD-Audio.
Amplifier’s rear panel
Amplifier’s rear panel
To AUDIO OUT 5.1 ch
To enjoy multi-channel surround sound on DVD-Video and
DVD-Audio connect an amplifier using the AUDIO OUT 5.1 ch
terminals and go to the settings on page 15.
≥Switch the attenuator on if sound is distorted with this
connection (➡ page 63).
or
Connect with AUDIO OUT1 or 2 terminals to enjoy
stereo (2 channel) sound.
Other antenna connections to the unit
300–75 ≠ transformer
from the antenna
(Flat) Twin lead
300 ≠ cable
To this unit’s RF IN
terminal
from the antenna
(Flat) Twin lead 300 ≠ cable
To this unit’s RF IN
terminal(Round)
75 ≠ coaxial cable
VHF/UHF band mixer
from the antenna
To this unit’s RF
IN terminal
300–75 ≠ transformer
(Flat) Twin lead
300 ≠ cable
VHF/UHF band mixer
Other antenna connections from the unit to the
television
VHF/UHF band separator
Telev is ion
75 ≠ coaxial cable
VHF
UHF
75 ≠ coaxial cable
75–300 ≠ transformer
Television
VHF or
UHF
75 ≠ coaxial cable
VHF/UHF band separator
Television
VHF
UHF
ANT 2
ANT 1
Split out
Te lev is io n
75 ≠ coaxial cable
7394en.book 9 ページ 2004年7月20日 火曜日 午後7時26分