Filter
Top Products
DRM-7000 Operating Instructions
A similar message appears when a magazine is removed from the Changer.
M1 Locked – type
out
If these messages appear repeatedly in rapid succession, the magazine is improperly
inserted into the bay. Remove the magazine and remount the unit into the appropriate
Changer bay.
4.7 Magazine Slot Assignments
Each possible slot in the Changer bays is assigned a unique serial number. These numbers
remain the same if the bay holds a magazine or a drive. Changing magazines does not change
the slot serial number. The following chart identifies each bay and the corresponding slot serial
numbers assigned to that bay.
Disc Storage Location Slot Number
(Disc Number)
Disc Storage Location Slot Number
(Disc Number)
Slot 20 # 770 Hyp-20 Slot 50 # 750 M15 – 50
to to to to to to
Hyper Magazine
Hyper
Slot 1 # 751 Hyp-01
Magazine Bay 15
M15
Slot 1 # 701 M15 – 01
Slot 50 # 350 M7 – 50 Slot 50 # 700 M14 – 50
to to to to to to
Magazine Bay 7
M7
Slot 1 # 301 M7 – 01
Magazine Bay 14
M14
Slot 1 # 651 M14 – 01
Slot 50 # 300 M6 – 50 Slot 50 # 650 M13 – 50
to to to to to to
Magazine Bay 6
M6
Slot 1 # 251 M6 – 01
Magazine Bay 13
M13
Slot 1 # 601 M13 – 01
Slot 50 # 250 M5 – 50 Slot 50 # 600 M12 – 50
to to to to to to
Magazine Bay 5
M5
Slot 1 # 201 M5 – 01
Magazine Bay 12
M12
Slot 1 # 551 M12 – 01
Slot 50 # 200 M4 – 50 Slot 50 # 550 M11 – 50
to to to to to to
Magazine Bay 4
M4
Slot 1 # 151 M4 – 01
Magazine Bay 11
M11
Slot 1 # 501 M11 – 01
Slot 50 # 150 M3 – 50 Slot 50 # 500 M10 – 50
to to to to to to
Magazine Bay 3
M3
Slot 1 # 101 M3 – 01
Magazine Bay 10
M10
Slot 1 # 451 M10 – 01
Slot 50 # 100 M2 – 50 Slot 50 # 450 M9 – 50
to to to to to to
Magazine Bay 2
M2
Slot 1 # 051 M2 – 01
Magazine Bay 9
M9
Slot 1 # 401 M9 – 01
Slot 50 # 050 M1 – 50 Slot 50 # 400 M8 – 50
to to to to to to
Magazine Bay 1
M1
Slot 1 # 001 M1 – 01
Magazine Bay 8
M8
Slot 1 # 351 M8 – 01
Note: Although slot numbers range up to 770, it may not be possible to insert a total of 770 discs
simultaneously.
4.8 Closing Changer Access Doors
Before closing the access doors, verify that all components are mounted correctly and that all
cables are firmly in place. Closing the access doors begins the initialization of the DRM-7000.
- 18 -