Filter
Top Products
DRM-7000 Operating Instructions
Problem Description Message Display Possible Cause Recommended Action
SCSI cable is disconnected Make sure that the SCSI cables are
connected properly
SCSI ID or termination settings
are incorrect or missing
Verify that all devices have unique
IDs and that drives are terminated
properly
Total length of the SCSI cables is
too long
Re-configure the SCSI chain so that
the total length of all cables is less
The host computer fails to
recognize a drive although the
Config submode lists the drive(s)
No Error Message
Operator has forgotten to reboot
the host computer
Reboot the host computer
The power cable for that drive is
disconnected
Open the rear access panel and
check the power cable connection
The host computer fails to
recognize a drive but the Config
submode lists the SCSI ID is 7
scsiID=7 TermOFF
dev-ID=
Drives have been inserted in rear
bays #9 through #16 without
adding an additional power supply
The power from the standard-
equipment power supply supports
functioning drives in bay #1 through
#8. Re-install the drive in one of
these bays or add a power supply.
The disc is upside-down Flip the disc right-side-up Unable to properly read a disc from
a drive
No Error Message
The disc is soiled or scratched Wipe the disc and check for damage
An error code appears on the LCD
display and the background flashes
while the buzzer sounds
E89, E99, etc. A mechanical error has occurred
which has locked up the system
In System Administrator mode, open
the access door and make changes
to clear the error
SCSI termination switch on the
Changer is set to OFF or
Turn OFF the changer then set the
SCSI termination switch to ON before
powering up the unit
The LCD display fails to appear
when the power is turned ON and
pressing buttons has no effect
No Error Message
SCSI cable is improperly
connected
Turn OFF the power and reseat the
cable connection before powering up
the unit.
- 47 -