Filter
Top Products
DRM-7000 Operating Instructions
The slot must be empty in order to use this command. It the slot contains a
disc or is unknown to hold a disc when the Enter button is pressed, the
message on the LCD display remains unchanged.
If the specified slot is empty, the mail slot tray opens and the following
message appears on the LCD display.
Place a new disc
& press ENT-key
Place a disc on the mail slot tray and press the Enter button. The following
message appears on the LCD display:
The new disc is
moving to #***
When the slot contains the new disc, the LCD display changes to the initial Add
message showing the next available slot.
To exit the mode, press the Enter button again.
Note: If you are unable to insert a new disc using the Add mode, add the disc in the
Swap mode instead.
5.2.6 Hyper Submode
Use the Hyper submode to eject hyper magazines through the Changer’s control panel.
The Enter button acts as an eject button when the DRM-7000 is in this mode.
(Hyper)
Eject & Inject
Pressing the Enter button causes the Changer to check the drives for discs
registered to a hyper magazine. If any hyper magazine discs are in a drive, the
following message appears on the LCD display.
Host must return
all hyper’s disc
The host computer has the authority to return discs to the magazine slots. The
system must be in User mode when the host computer issues the command.
Once any/all discs are returned to the hyper magazine, the following message
appears on the LCD display.
Press ENT-key
to eject
Pressing the Enter button causes the system to eject the hyper magazine.
Hyper – magazine
is unloading
Hyper – magazine
Is ejected
- 36 -