Filter
Top Products
DRM-7000 Operating Instructions
6.0 Optional/Additional Components
6.1 Adding Drives
Any drive designed for use in the DRM-7000 may be easily added to this system. The power
supply shipped with the unit is capable of supporting up to eight additional components. Install
the devices in to the lower rear bays (bay 1 through bay 8). To add drives or other components
to the remaining rear bays (bays 9 thought bay 16), install an additional power supply.
Touch a separate metallic surface to discharge static electricity before handling a power supply
or another component. Avoid any contact between your body and the power supply
connections when installing into the Changer.
• Install an add-on connector board if
necessary
1. Install the drive unit(s)
No tools are required to install a drive. While drives may be installed in any of the rear bays
(bay 1 through bay 8), the connector board shipped with the Changer is configured for drives to
be installed into bay 1 and bay 2.
• Specify the SCSI IDs and set the
termination switches on the back of
the drives before installing the units
• Verify that the drives are mounted on
the guide rails
• Listen for the clicking sound as the
drive is pushed into the bay
• Push the drive in until the lock lever
on the drive shifts to the locked
position
- 39 -