Filter
Top Products
DRM-7000 Operating Instructions
5.0 Operation
The DRM-7000 supports two modes, User and System Administrator. Separating the operations
into two modes prevents interference, conflicts, or clashes from occurring between commands
issued from the host computer and commands entered at the Changer’s Control Panel.
5.1 User Mode
Upon installation, the Changer enters the User Mode. This mode allows the Changer’s
controller software or database management software on the host computer to run the unit.
When operating in the User Mode, the Changer flashes a series of messages shown below.
Robotics ready
Drive1 no disc
Robotics ready
Drive2 no disc
Robotics busy
Drive1 no disc
Robotics ready
Drive2 has #205
When in the User Mode, the Changer responds to commands issued from the host computer.
5.2 System Administrator Mode
Issuing commands from the Changer’s Control Panel is restricted to System Administrators
with the panel keys. To switch the System Administrator Mode, follow the steps below.
1. Insert the key into the key switch located on the control panel.
2. Rotate the key 90 degrees to the unlocked position.
3. Press the Function button to enter the System Administrator Mode.
- 20 -