Filter
Top Products
Chapter 2 Fitting and Connecting Related Equipment
Chapter 2 Fitting and Connecting Related Equipment 33
LOCK
Detaching the battery pack
Avoiding breaks in operation due to dead batteries
If you use both an internal battery pack and an external battery connected
to the DC IN connector at the same time, you can avoid breaks in
operation due to the dead batteries.
When the external battery begins to fail and an internal battery
pack is also used
Remove the DC output cable of the external battery from the DC IN
connector. The power source will switch to the internal battery pack.
When the external battery begins to fail and an internal battery
pack is not used
First load the DSR-1/1P with a fully charged internal battery pack, then
remove the DC output cable of the external battery from the DC IN
connector. The power source will switch to the internal battery pack. To
use an external battery again, connect a fully charged external battery to
the DC IN connector before unloading the internal battery pack. The
power source will switch to the external battery.
Continuous operation when operating with only an internal
battery pack
First, connect a fully charged external battery to the DC IN connector, then
change the internal battery.
Notes
• Whenever an internal battery pack is loaded and an external battery is
connected to the DC IN connector, the external battery is always used as
the power source.
• There may be some noise on the video or audio signal at the instant the
power sources are switched.
Holding the button in,
pull the battery pack
up.