Filter
Top Products
Chapter 4 Time Values
Chapter 4 Time Values 51
This section describes the steps for setting time code
recording methods for particular shooting conditions
and setting initial values.
When using both the time code and user bits, set up
the user bits first. If you set the time code first, the
internal time code generator will remain stopped while
you set the user bits, which will set the time value off
from the original setting.
Setting the Time Code Value
For details of setting user bits, see “Setting the User Bit
Value” on previous page.
Note
Setting the time code value may be disallowed in some
cases at ClipLink shooting. For details, see step 4 on
page 56 in Chapter 5 “ClipLink Shooting”
1 Set the DISPLAY switch to TC.
2 Set the TC mode switch 1 to PRESET.
3 Set the TC mode switch 2 to SET.
This causes the leftmost digit in the time code
display to start blinking.
4 Set the time code initial value.
The time code value can be set anywhere in the
range of “00:00:00:00” to “23:59:59:29” (DSR-1)
or “23:59:59:24 (DSR-1P).
∞
H MIN SEC FRM
1
dB
2
PB DATE NDF EXT-LK HOLD
CLIP
TAPE
BATT
DIAG
EF
RF SERVOHUMIDSLACK
Li
-
-40
-30
-12
0
IP
CL
CONT
OVER OVER
WARNING
RESET
(MENU SET)
MENU ADVANCE SHIFT
ALARM
MONITOR
PRESET
DATE/TIME
ClipLink CONTINUE
MONITOR SELECT
BACK TALLY
LIGHT
DISPLAY
AUDIO LEVEL
AUDIO SELECT
AUDIO IN
CH-2
CH-1
OFF
ON
MIX
REGEN SET
F-RUN
R-RUN
AUTO
MANUAL
CAM
REAR
ON
OFF
COUNTER
TC
U-BIT
CH-1 CH-2
-20
DVCAM
F832k
F848k
2 3,6
1
45
Operation Step
Select a
digit
Press the SHIFT button.
Each time you press the SHIFT button,
the next digit to the right starts blinking.
Change a
value
Press the ADVANCE button.
Each time you press the ADVANCE
button, the displayed value increases.
Reset Press the RESET/(MENU SET) button.
The display returns to “00:00:00:00”.
5 For the DSR-1, use menu 204 to select the frame
mode.
For more information about the drop-frame/non-drop-
frame mode, see “Drop-frame mode (for DSR-1 Only)”
on next page.
For details of menu operations, see page 63.
(Continued)
Operation Step
Adjust the discrepancy bestrewn
time code value and real time
Select the drop-
frame mode.
Need not adjust the discrepancy
bestrewn time code value and
real time
Select the non-
drop-frame mode.