Filter
Top Products
Chapter 3 Shooting
38 Chapter 3 Shooting
This section describes basic shooting operations using the DSR-1/1P.
Notes
• When you will not perform ClipLink shooting, set the ClipLink function
to oFF in the VTR menu.
See page 67 for menu setting and see Chapter 5 for details of ClipLink shooting.
• Before shooting, mount or connect any required equipment or accessories
and check the power supply.
See Chapter 2 “Fitting and Connecting Related Equipment”.
Also, it is desireable to make sure for problems in VCR’s internal
operations and the VCR/Camera connection using the auto-check
function.
See “Using Auto-Check Function —Menu 210” on page 65.
• When using a tape recorded by the DSR-1/1P to transfer digital (video/
audio/time code) signals at four times normal speed from the DSR-85/
85P Digital Videocassette Recorder to the ES-7 EditStation for editing
purposes, there must be about at least 40 seconds of recording on the tape
before the IN point. To perform editing without problems, it is
recommended that you pre-record at least 40 seconds of color bar signals
at the beginning of the tape.
1 Set the POWER switch to ON and check the following items in the
display window.
Shooting
31
41
2
Item to check Indication and steps See also
How is the
battery?
BATT E (pppppp) F: The battery
is fully charged.
If two or fewer marks appear and the
indication is blinking, replace the
battery.
“1 Display window”
in the “Display
Section” (page 11)
Make sure that the
Li
is not shown in
the display window. If it is shown,
replace the lithium battery.
“Inserting and
Replacing the
Lithium Battery”
(page 21)
Is there a
condensation
problem?
“Condensation”
(page 73)
Has the lithium
battery been
inserted and is
it charged?
Make sure that the “HUMID”
indication is not shown in the display
window. If it is shown, do not use the
equipment until the “HUMID”
indication disappears.