Filter
Top Products
9
INTRODUCTION
4. INSTALLATION AND CONNECTIONS
The digital video recorder has ventilation holes. Make sure
these holes are not blocked after installation. Do not use
the unit in areas with poor ventilation, such as a bookshelf
or box. When installing the unit in a rack, ensure a gap of at
least 5 cm at the top and bottom.
Make sure the TV SYSTEM selector switch on the rear
panel is set to “NTSC”. (P.8)
Disconnect the power and then connect it again after
selecting NTSC or PAL.
This section describes how to connect the digital video recorder to CCTV cameras and other devices. Be sure to read the
instruction manuals for each connected device. Make connections carefully. Improper connections can cause smoke or
malfunctions.
The connections for cameras (4), TV monitor (1), microphone and PC are shown below.
When installing Check the setting
Basic connections
AUDIO
IN
3
4
1
2
OUT
LAN
1
123456789
10 11 12 13 14 15 16 17 18 19
234
1234
IN
OUT
MONITOR OUT
AC IN
VIDEO
ALL
RESET
ON
NTSC
PAL
TV SYSTEM
RS-485
TERMINATE
MIC IN
OFF
*1 Use a shielded LAN
connection cable, and wind
it once around the supplied
ferrite core.
TV monitor
(sold separately)
Video input terminal
CCTV camera (sold separately)
PC (sold separately)
switching hub
(sold separately)
or
Microphone
(sold separately)
Amp
(sold separately)
*1
Microphone
(sold separately)
Audio input terminal
e00_VDH_M814.book Page 9 Thursday, October 28, 2004 9:59 AM