Filter
Top Products
25
MENU
LANGUAGE
Lists the languages available for the On Screen Display menus.
INPUTS LIST
In order to make the HTL40 LINK system increasingly flexible, the
functions described below make it possible to modify the inputs
selection menu and adapt it so that it matches the requirements
of the user more closely.
The main page displays all the inputs physically present on the
DigiOptic™ Image Processor.
If one or more of the inputs is not used, they can be hidden in the
list, which is called by pressing the 0 key.
For this purpose select
SOURCES LIST
and position the cursor on the
line corresponding to the input you wish to hide. Now press the
◀
key and select activation or deactivation of the relative source
(Fig.24).
The deactivation or activation of the source results in automatic
renumbering of the remaining active inputs.
Fig.24
Active video signal sources (shown in the inputs selection menu)
are distinguished by tick symbols.
You can also identify the input with a more significant name for the
user (e.g. with the name of the connected device).
The current source can be renamed in the pull-down menu.
For this purpose, after selecting the display of a given input, select
the option Name. This function is designed to facilitate the identi
-
fication of a source connected to a particular input.
To assign a name to a source you can use up to twelve alphanumeric
characters (for more details refer to the following section).
Table 4
SETUP
The setup menu contains less frequently used adjustments that may
be required during installation (e.g. On Screen Display language
selection or the display of Test Patterns).
POWER ON
If selected (AUTO), this option allows the system to be switched on
directly from the mains power supply once the initialisation phase
is terminated.
If disabled (STAND BY), at the end of the initialisation phase the
system assumes Standby status and awaits the power-up command
from the remote control or keypad.
TEST PATTERNS
Displays a series of five test patterns, which are useful when install-
ing the system and checking basic functions. Use the
▲
and
▼
keys
to browse through the test patterns
INITIAL SETTINGS
Restores original factory settings except for Position, Orientation,
Y/C Delay, Zoom and Focus.