Filter
Top Products
7
• Read this manual carefully and keep it in a safe place
for future consultation.
This manual contains important information on how to install
and use this equipment correctly. Before using the equipment,
read the safety prescriptions and instructions carefully. Keep the
manual for future consultation.
• Do not touch internal parts of the units.
The units contain electrical parts carrying high voltages and
operating at high temperatures. Do not remove the cover from
the units, refer to qualified service personnel for all repair and
maintenance requirements. The warranty will be automatically
invalidated if the cover is removed from the units.
• Power supply disconnect device.
The device for disconnecting the units from the mains power
supply is constituted by the power cable plug. Ensure that the
power cable plugs and the electrical mains socket outlets are
easily accessible during installation operations. To disconnect the
units from the electric power supply, pull the plug to remove it
from the socket outlet. Do not pull the power cable.
• Connect the unit only to the type of power supply indi
-
cated.
Connect the units to a mains electrical supply with rated voltage of
between 120-240 Vac, 50/60 Hz and equipped with a protective
earth connection. If you are unsure of the type of mains power
supply in your home, consult a qualified electrician. Ensure that
the power draw of the units is commensurate with the rating of
the electrical socket outlets and any extension cables that are
used. For the DigiOptic™ Image Processor use exclusively the
power supply unit provided or an alternative power supply unit
expressly approved by SIM2.
• Connection of the units to the mains power supply.
Make the connection as shown in Fig.1. Before connecting the
panel to the electrical mains supply, follow the setup instructions
carefully.
Fig.1
�
�
Fig.2
• Changing the fuses.
Before changing the fuse disconnect the unit from the
mains power supply.
The fuse compartment is next to the mains power connector
(Fig. 3). Remove fuse carrier (2) with the aid of a flat blade
screwdriver, then change fuse (3). Insert a new spare fuse (4).
Use only T 3.15A H fuses.
Fig.3
• Be careful with cables.
Position the power supply cables so that they do not constitute
an obstruction.
Keep cables out of the reach of small children.
Install the units as close as possible to the wall electrical socket
outlet. Do not tread on the power cables, make sure that they
are not tangled or pulled; do not expose the power cables to
heat sources; make sure that the power cables do not become
knotted or kinked. If the power cables become damaged, stop
using the system and request the assistance of an authorised
technician.