Filter
Top Products
Chapter 11 Function Menu
Chapter 11 Function Menu 11-3
11-2 Function Menu Item List
The function menu has the following items.
HOME page
a) The selection of LTC or VITC depends on the setting of
F6 (TCR) in function menu page 1.
Item
F1 (VID.IN)
F2 (PB/EE)
F3 (CONFI)
F4 (CTL/TC)
F5 (MENU)
F6 (TCGSET)
Setting
Selects the input video signal.
COMPST: Analog composite signal
Y-R,B: Analog component signal
SDI: SDI signal
SG (normally not displayed): Test signal from the internal test signal generator
(For details, see setup
menu item 710 on page 12-22.)
Selects the video and audio signals output during fast forward, rewind, stop, and standby.
PB: Playback signals
EE: E-E mode signals
Selects whether or not to use the CONFI playback function when recording.
ENABLE: Use the CONFI playback function. (The CONFI indicator lights in the time data display.)
DISABL: Do not use the CONFI playback function.
Selects the time data to display in time data display area 1
(see page 2-7)
.
TC: Playback time code read by the internal time code reader, or recording time code. The LTC or VITC
time data type indicator
(see page 2-7)
lights.
a)
UB: User bits data of playback time code or recording time code. The LUB or VIUB time data type
indicator lights, depending on whether the time code is LTC or VITC.
a)
CTL: The running time of the tape being played back or recorded, as calculated from a count of CTL
signals recorded on the tape. The time is displayed in Hours: Minutes: Seconds: Frames format.
Puts the system into setup menu mode
(see Chapter 12)
.
When the current setup menu settings are the same as the contents of any of menu banks 1 to 4, or the
factory defaults, the corresponding indication (1), (2), (3), or (dflt) appears.
(1): Same as menu bank 1.
(2): Same as menu bank 2.
(3): Same as menu bank 3.
(4): Same as menu bank 4.
(dflt): Same as factory defaults.
• When F4 (CTL/TC) is set to TC, a screen appears that allows you to set the initial value of the time code
generated by the internal time code generator
(see page 4-3)
.
• When F4 (CTL/TC) is set to UB, a screen appears that allows you to set the time code user bits
(see
page 4-3)
.