Filter
Top Products
5-2 DMC Editing
Chapter 5 Editing
5-12 Chapter 5 Editing
5-2-2 Carrying Out DMC Editing
Setting the edit points and player speed
Use the following procedure.
1 Press the ASSEMBLE button or the desired
INSERT button to select the editing mode.
2 Press the DMC EDIT button.
This unit switches to the DMC editing mode, and
the DMC EDIT button lights.
3 Press the RECORDER button.
4 Holding down the ENTRY button, press the IN or
OUT button to set an edit point.
5 Press the PLAYER button, to set the player IN
point.
Note
It is not possible to set the player OUT point.
6 Holding down the DMC EDIT button, turn the
search dial, to set the initial speed.
To select normal speed as the initial speed, press
the PLAY button.
The speed you set appears in the speed indication
area.
7 When the initial speed setting is complete, release
the DMC EDIT button.
8 Press the PREVIEW button.
The tape is prerolled and then the recorder starts
operating at normal speed and the player at the set
initial speed.
9 On passing the IN point, the MEMORY indicator
begins to flash: turn the search dial to vary the
playback speed.
While the MEMORY indicator is flashing, the
speed variations are stored in memory. On passing
the OUT point, the MEMORY indicator changes
from flashing to continuously lit, and the variable
speed storing ends.
If the MEMORY indicator lights continuously
before the OUT point
This indicates that the memory became full at that
point. Thus even before the OUT point is reached, it is
not possible to record more speed variation.
The maximum capacity is a duration of 120 seconds.
Quitting the DMC edit mode
Press the DELETE button and DMC EDIT button
simultaneously.
Executing the DMC edit
Press the AUTO EDIT button.
DMC editing is carried out at the stored varying speed.
Once the editing is carried out, the stored speed
variation is lost from memory.
To check the editing results
Press the REVIEW button.
Z
482,6,7 31 6,95