Filter
Top Products
Chapter 12 Setup Menus
Chapter 12 Setup Menus 12-25
Menu items in the range 700 to 799, relating to video control (Continued)
Item number
726
727
728
733
Item name
H BLANKING WIDTH
VIDEO EDIT PREVIEW
SWITCHER
OUTPUT SCH PHASE
C.PHASE TYPE
Settings
Select the horizontal blanking width of the video output signal.
NAROW : Digital blanking (narrow)
WIDE: Analog blanking (wide)
When WIDE is selected, the horizontal blanking width complies with RS170A, and
normally the blanking is widened and the image becomes narrower. It is
recommended to select NAROW at the editing stage, then later, for broadcast
transmission to select WIDE, to output a signal conforming to the standard. Note,
however, that NAROW has to be always selected for SDI signals.
Set the output phase for the video playback signal when any of the ASSEMBLE,
VIDEO, AUDIO CH1 to CH4, CUE, and TC buttons is lit.
INT : The video playback signal output phase is the same as the output phase in
E-E mode. Use this setting when editing with a single VTR, or when
previewing while watching the VTR output signal.
EXT: The video playback signal output phase is the same as the phase of an
input video signal or external reference signal.
Note
Whichever setting is used, the correct editing results will be obtained. When,
however, you are using an external switcher to switch the video output signal
from this unit for the purposes of preview, select EXT. This will prevent any
image shifts at editing IN and OUT points.
Set the subcarrier H phase.
–2048 to 0 to +2047
Select the PAL chroma phase type. (DVW-M2000P/2000P)
HUE : Vary the hue.
L.ALT: Vary the SC phase of composite output.