Filter
Top Products
12-4 Items in the Extended Setup Menu
Chapter 12 Setup Menus
12-14 Chapter 12 Setup Menus
Menu items in the range 300 to 399, relating to editing operations (Continued)
Item number
316
317
318
319
320
326
334
336
Item name
CONFIDENCE PB MODE
AUDIO EDIT MODE
EDIT RETRY
PREREAD SELECT
DIGITAL AUDIO PB
PROCESS ON EDIT
POINT
AUTOMATIC IN ENTRY
AFTER AUTO EDIT
EE REFERENCE
CONTROL
EDIT PRESET INHIBIT IN
KEY PANEL CONTROL
Settings
Sets F3 (CONFI) in function menu HOME page to ENABLE.
For settings of F3 (CONFI), see page 11-3.
mode1: The CONFI playback function is only enabled during recording.
mode2 : The CONFI playback function is also enabled during normal playback
with the edit preset function being on, as well as during recording.
mode3: The CONFI playback function is only enabled during crash recording.
Note
Playback is performed in advance mode during auto edit previewing regardless of
the setting of this menu item.
Select the type of audio transition used for digital audio editing.
CUT: Cut editing (audio discontinuity at transition point, and possible noise during
playback).
CROSS : Cross-fade
FI/FO: Fade in and out
t: Time set by item 803 DIGITAL AUDIO FADE TIME
For two-VTR editing, set when this unit is used as the recorder. Selects the
operation if the recorder was not synchronized in time.
OFF: Editing is not carried out, and the unit stops.
ON : The editing is automatically retried (up to twice).
Specify the preread operation.
A/V : Preread for both audio and video.
AUDIO: Preread for audio only.
VIDEO: Preread for video only.
The preread operation is enabled when the function menu item PREREAD is set
to ON or with a command from the 9-pin remote control interface.
Select the treatment of audio playback at edit points.
CUT : Carry out a cut (possibly resulting in audio discontinuities at the edit point).
FADE: Fade out and fade in.
Select whether or not to automatically set the OUT point of the previous edit as
the next IN point at the end of an automatic edit.
OFF : No automatic setting
R: Set recorder IN point automatically.
R & P: Set recorder IN point automatically, and also player IN point in two-VTR
editing.
Specify how to select the reference video signal in E-E mode.
normal : Select according to the flowchart in Section 3-2-1 “External Sync Signal
for the Internal Reference Video Signal Generator”
(page 3-3)
.
input : In E-E mode select the input video signal. When not in E-E mode, select
according to the flowchart in Section 3-2-1 “External Sync Signal for the
Internal Reference Video Signal Generator”
(page 3-3)
.
Specify which buttons are disabled in the editing mode setting section on the
lower control panel.
off : Disable all buttons.
TC: Disable the TC button.
IN/OUT
t
IN/OUT
t