Filter
Top Products
Chapter 4 Dubbing to Other Equipment Using the i.LINK Jack, Duplication, Audio Dubbing, and Connecting a Computer 57
Chapter
4
Dubbing to Other
Equipment Using the i.LINK
Jack, Duplication, Audio
Dubbing, and Connecting a
Computer
Dubbing to Other Equipment Using the i.LINK Jack
This section describes the connections and settings
necessary to perform dubbing on other equipment, using
the unit as a video player.
Connect the unit to the recorder as shown on the right
using an i.LINK cable.
The signal flow is automatically detected so you do not
need to make separate connections for input and output.
Also, by connecting the unit to an editing controller via
the HDV/DV jack, you can configure a digital non-
linear editing system.
For connections of the editing controller and the unit, refer to
the editing controller instruction manual.
Before dubbing, you must set the format in which you
want to output signals. Make [HDV/DV SEL] (page 70)
and [i.LINK SET] (page 72) settings in the [IN/OUT
REC] menu.
For details, refer to “Major Differences among HDV1080i,
DVCAM, and DV Formats” on page 31.
For details on i.LINK output formats, see page 97.
To dub a tape recorded in HDV format using the
duplicate function on other units such as the DSR-25/
45/50, select [DVCAM] in [HDV t DV CONV] of
[i.LINK SET] in the [IN/OUT REC] menu.
Connections for Dubbing
HVR-M25A (rear panel)
Monitor
i.LINK cable (not supplied)
To i.LINK jack
Digital video equipment
with an i.LINK jack
: Signal flow
Monitor
(Continued)