Filter
Top Products
Operation Instruction
28
Highlight the box beside Daytime and press the button. Use the Up and Down
arrow buttons to set the Daytime range. The DVR will consider the remaining
time range as the Nighttime.
Highlight the Actions 1 and Actions 2 tabs, and the Motion Detection Actions 1 and Actions 2 setup screens appear.
The DVR can be set to react to motion detection differently
for each camera. Each camera can be associated with another
camera, trigger an Alarm-Out connector, sound the DVR’s
internal buzzer, notify a number of different devices, and/or
move PTZ cameras to preset positions.
NOTE: You can associate multiple cameras with a camera
that detects motion.
Highlight the box under the Record heading and press the
button. A list of cameras appears. You can associate as many
cameras with that camera as you wish. If the DVR detects
motion on the selected camera, it starts recording video from
all the associated cameras.
Figure 31 — Motion Detection Actions 1 screen.
NOTE: For the Record action, the camera you select should be set to the Event or Time & Event recording mode
in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the button. A list of Alarm Outputs appears. You can
associate as many Alarm-Outs with that camera as you wish. When the DVR detects motion on the selected camera’s
input, it triggers output signals on all the associated Alarm-Out connectors. You can also have the DVR’s internal
buzzer sound if motion is detected on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the button. You can toggle the entire list On and Off by
highlighting Notification and pressing the
button. You can toggle the individual items On and Off by highlighting
that item and pressing the
button. Highlight OK and press the
button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the Speco Central (Remote Administration System).
Highlight the desired box under the PTZ heading, and press
the
button. A list of PTZ presets appear. Select the preset
position for each PTZ camera, where you want PTZ cameras
to move to whenever the DVR detects motion on the selected
camera’s input.
Highlight the desired box under the Digital Deterrent heading,
and press the
button to toggle between On and Off. When
set to On, the DVR will sound whenever it detects motions
on the selected camera.
Figure 32 — Motion Detection Actions 2 screen.
Video Loss
Highlight Video Loss in the Event menu and press the
button. The Video Loss setup screen appears.