Filter
Top Products
Operation Instruction
38
Highlight the Check box and press the
button to check whether or not the name you entered can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the DVRNS changes will
not be saved.
When entering no name or a name already registered on the DVRNS server, an error message displays.
Highlighting Save and pressing the button registers the DVR on the DVRNS server. Proper DVRNS settings will
display the help desk information of the DVRNS server in the box beside Help Desk.
Highlight the RTSP tab, and the RTSP setup screen displays.
Figure 48 — RTSP setup screen.
Highlight Enable RTSP (Real-Time Streaming Protocol) and
press the
button to toggle between On and Off. You will
be able to change the settings if Enable RTPS is enabled.
Highlight the box beside RTSP Port and press the button.
Set the port number of the RTSP server obtained from your
system administrator.
Highlight the box beside RTP Start Port and press the
button. Set the start port number of the RTP server obtained
from your system administrator.
Highlight the box beside RTP End Port and press the
button. Set the end port number of the RTP server obtained
from your system administrator.
Highlight Use Mobile and press the
button to toggle between On and Off. When set to on, you can access a remote
DVR using a Blackberry or other mobile devices.
NOTE: Selecting Use Mobile sets the Speco Remote service to be enabled automatically regardless of Speco
Remote settings.
You can access a remote DVR and monitor live video images using media players, such as VLC Player,
supporting RTSP service. Start the media player on your local PC and enter “rtsp://ID:Password@IP
address:RTSP port number/track ID=‘channel number’”, or start Internet Explorer on your Blackberry
or other mobile devices and enter “http://IP address:Speco Remote port number/”.
Some media players might play video properly depending on network conditions.
RTSP service might not be supported, depending on the type of media player.
Highlight the Speco Remote tab, and the Speco Remote screen displays.
Highlight Use Speco Remote Service and press the
button to toggle between On and Off. See Appendix – Speco
Remote for detailed descriptions of the Speco Remote service.
Highlight the box beside Port and press the button. Set
the port number used when accessing Speco Remote by using
the Up and Down arrow buttons to increase or decrease the
numbers.
Figure 49 — Speco Remote setup screen.
Notification
Highlight Notification in the Network menu and press the
button. The Notification screen displays.