Filter
Top Products
Instruction Manual
16
The Admin functions allow you to access all of the features you will need to perform an
initial configuration of the SV1115IPEXT.
Dynamic Host Configuration Protocol (DHCP)
Automatic network configuration using DHCP is: Enabled/Disabled. This feature applies
only to the LAN port on the rear panel, and is enabled by default. When enabled, the
unit will automatically configure itself with an IP address when a DHCP server is present.
When disabled, the LAN port will use the values assigned to it on the IP Addresses and
Routing table below.
IP Addresses and Routing
This table allows you to assign IP information for the LAN and WAN ports separately. If
you are using DHCP, the values for the LAN port will be filled in automatically and any
changes made will not affect the setup. If Ethernet Bridging is enabled, the WAN port
will use the same settings as the LAN port, and any changes will not affect the setup for
that port. Adjusting the setting for the WAN port allows you greater control over how the
SV1115IPEXT is configured for access from outside the local network, particularly if a
firewall or proxy is in use.
This section allows you to specify DNS servers and the default DNS domain suffix in use
on the network. If DHCP is enabled, some of these values may be supplied
automatically.
Domain Name Server (optional)
Clicking the Commit button applies any changes made on this page, but leaves the old
settings active until the next time the unit restarts. Clicking Make changes effective
now applies the changes and restarts SV1115IPEXT so the new settings take effect
immediately.