Filter
Top Products
2–Pump 12-Station Controllers Chapter 3: Installation 24
TO SELECT A STATION
PRESS STATION <1-12>
ALARM 11: ENABLED
Y=ENABLE N=DISABLE
Each station has its own No Convey alarm settings. You can enable or disable alarms as
needed. If a station doesn’t receive (or dump) material after a user definable number of load
attempts, the controller activates an alarm condition. Perform the following procedure to set
alarm conditions.
To alter the Input Delay time:
• Press the YES key.
The following screen displays.
To alter stations alarm settings:
• Select a station to alter, then press the related Station STnn key. nn is the station
number you selected.
The screen displays the selected station (11 in the following example) and the current
station alarm setting.
To enable the alarm:
• Press the YES key.
The alarm is enabled on the station you selected.
If you want to disable the alarm:
• Press the NO key.
The alarm is disabled on the station you selected.
The controller increments to the next station in sequence.
To retain the original setting:
• Press the SET key.
The next station in the sequence displays.