Filter
Top Products
2–Pump 12-Station Controllers Chapter 4: Operation 36
STATION:-- OFFLINE
TIME: --- LOGO
P1:S--:--- OFFLINE
P2:S—-:--- OFFLINE
Pump Modes
Single Pump Mode
In Single Pump mode, the screen displays as shown below. The upper left corner displays the
active station being loaded. If the system has no active station, two (2) hyphens
-- in the
station area display. The lower left corner displays the load time in seconds. When a station is
loading, this area displays how much time elapses during the load cycle. If no station is
active, three (3) hyphens
--- display.
The upper right area displays the status of the control. This section displays the condition of
the controller, and what action is occurring in the loading sequence. The different status
displays are described on Pages 24 and 25.
The lower right section of the display is not used in Single Pump mode. It simply displays the
manufacturer’s logo.
Dual Pump Mode
In Dual Pump mode, the screen displays as shown on the following page. The first line of the
screen displays information for Pump 1 and the second line of the screen displays information
for Pump 2.
Each line has twenty (20) characters divided into two (2) groups of ten (10). From the left
character position, P0 S:--:--- is read as “Pump 0 Station --:Load Time ---.” This screen
displays important information in an easy-to-read display. The right ten (10) character group
displays the status of the specific pump. Again, the different status displays are described on
Pages 24 and 25.