Filter
Top Products
Quick Reference Guide
Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder Page G-3
ST.TM.E10100.1
G.1 Setting Up the Input
G.1.1 Satellite Receiver
Table G.1 steps through the setting up the Satellite Receiver using
Menu #2 Input, and the QPSK 1 and 2 inputs. The transmission
parameters must be known before starting.
Table G.1: Tuning the Satellite Receiver
Step Action
1 Connect the cable to the QPSK 1 input.
2 Power up the unit and navigate to Menu # 2 Input.
3 Press the Right pushbutton to access Menu # 2.1, then press Edit.
4 Use the Up and Down pushbuttons to SELECT SOURCE 1, then press Edit.
5 Navigate to Source 1, LNB FREQUENCY (Menu # 2.3), then press Edit.
Enter the desired LNB frequency in MHz, then press Save.
6 Navigate to Source 1, SATELLITE FREQUENCY (Menu # 2.3.1) then press Edit.
Enter the desired Satellite frequency in MHz, then press Save.
7 Navigate to Source 1, SYMBOL RATE (Menu # 2.3.2) then press Edit.
Enter the symbol rate in megasymbols, then press Save.
8 Navigate to Source 1, MODULATION FEC (menu # 2.3.3) then press Edit.
Select the desired modulation form and FEC rate, then press Save.
9 Navigate to Source 1, LNB POWER (menu # 2.3.4) then press Edit.
Select the LNB power setting and select the desired voltage level, then press Save.
10 Navigate to Source 1, LNB 22 kHz (menu # 2.3.5) then press Edit.
Select to enable or disable 22 kHz tone, then press Save.
11 Navigate to Source 1, SEARCH RANGE (Menu # 2.3.6) then press Edit.
Enter the search range for the centre frequency in kHz, then press Save.
12 Return to Input Menu # 2.1, it should display the current status. If status is NOT LOCKED, verify that the cable is
properly connected and that all values have been entered correctly.
13 To configure QPSK Input 2, connect the cable to the QPSK 2 input, then repeat steps 4 to 11. However, use the
Source 2 menus for the input configuration.
G.1.2 Decoder
Table G.2 steps through the setting up the Decoder using Menu #2 Input,
and the ASI 1 and 2 inputs. The transmission parameters must be known
before starting.
Table G.2: Setting-up the Decoder
Step Action
1 Connect the ASI cable to either of the ASI inputs, ASI 1 or ASI 2.
2 Power up the unit and navigate to Menu # 2 Input.
3 Press the Right pushbutton to access Menu # 2.1, then press Edit.
4 Use the Up and Down pushbuttons to select the correct source.
If only one of the inputs has an active connection, the input can be left at AUTO. Press Save.
5 Verify the connection status in the Input Menu # 2.