Filter
Top Products
Installing the Equipment
Page 2-6 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
WARNINGS…
1. THE TT1260 SHOULD ONLY BE OPERATED FROM THE TYPE OF POWER SOURCE
INDICATED ON THE MARKING LABEL. IF YOU ARE NOT SURE OF THE TYPE TO YOUR
BUSINESS, CONSULT YOUR APPLIANCE DEALER OR LOCAL POWER COMPANY. DO NOT
OVERLOAD WALL OUTLETS AND EXTENSION CORDS AS THIS CAN RESULT IN A RISK OF
FIRE OR ELECTRIC SHOCK. AC SUPPLY.
2. THE TT1260 RANGE OF RECEIVERS AND DECODERS ARE NOT FITTED WITH AN AC
POWER ON/OFF SWITCH. ENSURE THE SUPPLY SOCKET OUTLET IS INSTALLED OR
LOCATED NEAR THE EQUIPMENT SO THAT IT IS ACCESSIBLE.
Figure 2.2: AC Power Inlet Assembly
Table 2.1: Fuse Information
Item Specification
Fuse Single pole, fitted in live conductor in power input filter at rear of unit.
Fuse type 5 mm x 20 mm anti-surge (T) HBC, IEC127 (sheet v)
Fuse rating 1.6 A
Fuse rated voltage 250 Vac
Power lead connector fuse (if appropriate) 5 A
NOTE...
See Annex B, Technical Specification for more fuse information.
2.5.2 AC Power Supply Cord
General
A two-metre mains supply cord is supplied with this product. It is fitted
with a moulded plug suitable for the USA, UK or mainland Europe as
advised at the time of ordering.
NOTE...
The TT1260 is not fitted with an ac power supply ON/OFF switch. Ensure the socket-outlet supplying
the equipment is installed near the equipment so that it is easily accessible.
Wire Colours
The wires in the supply cord are coloured as shown in Table 2.2.
Position of the fuse carrier
Supply Inlet Mains